§ 249-20. Lots.

A. 

Lot size. All lots shall have area and width equal to minimum requirements of the zoning regulations, if any, and New York State Department of Health regulations (pursuant to Public Health Law § 1115 and following) applying to the district in which they are located. Larger lots may be required if necessary to carry out the purposes of this regulation.

B. 

Side lines. Side lines of lots shall be approximately at right angles to straight street lines and radial to curved street lines, unless a variance from this rule will give a better street or lot plan.

C. 

Corner lots. In general, corner lots should be larger than interior lots to provide a desirable building site with proper building setback from each street.

D. 

Driveway access. Driveway grades between the street and the setback line shall not exceed 7%.

E. 

Access from private streets. Lots on private streets shall be deemed acceptable only if such streets are designed and improved in accordance with these regulations unless overall design is improved by an alternative.

F. 

Monuments and lot corner markers. Permanent monuments meeting specifications approved by the Town Engineer as to size, type and installation, shall be set at such block corners, angle points, points of curves in streets and other points as the Town Engineer may require, and their location shall be shown on the subdivision plat.